V2 LIT LOGOS ARE HERE
We are always striving to make our products better and better. There have been consistent changes throughout the years behind the scenes to continually improve. We are now able to upgrade our logos to light up your ride better than ever before!
Introducing our V2 Lit Logos!
GET LIT AND STAY LIT
- Wall to Wall LED's: We have been able to make our logos more evenly lit by using a custom LED board that is designed exclusively for our products and your vehicle!
- Bright AF: We now use more than double the number of LED's for every logo! More LED's means you'll be able to see your logo even better during the day, and it'll turn more heads at night!
- Thinner than Ever Before: The use of these new LED boards has allowed us to shrink down the thickness of our logos substantially! Our STI Lit Logo is now HALF as thick as our previous version.
WHAT IF I ALREADY HAVE A LIT LOGO?
If you already have one of our products, THANK YOU for supporting us! We will never forget the original customers who supported us from the beginning. We want to provide you with a path to upgrade your older Lit Logo to our new V2! The upgrade path looks a little different depending on when you ordered and what your current logo and wiring looks like. This can get a little complex but we have done our best to simplify it for you.
Below is pictured the key difference to tell if you have a V1 or V2 Lit Logo. If you have purchased an STI or WRX Lit Logo within the last 6 months, there's a good likelihood you already have a V2 Lit Logo. So please be sure to check first!
STI: The best way to tell if you have a V2 for the STI is to look at the thickness of the logo.
WRX: The best way to tell if you have a V2 for the WRX is to look at the right side of the X. If the X section is cut out, you have a V1. If the right side is not cut out, you have a V2.
ST: If you ordered your ST Lit Logo prior to 8/1/2022, you have a V1 ST Lit Logo.
I HAVE A V1 LIT LOGO, NOW WHAT?
Hang in there, this is the final step! From here, we need to check and see what style of connector you have on your logo. We have swapped connectors a couple times in the past, and some look very similar to others.
You will need to gain access to the backside of the logo, where the wire comes out of it. Follow that wire to the connector between the logo and the control box. Please disconnect the connector, and take a look at the side that is connected to the logo. Below are listed connector styles 1 through 4. Please determine which style connector you have by referencing the pictures below.
To clarify, this is the connector that is on the logo side not the control box side. Please take a picture of the connector for confirmation and remember which style you have.
Now that you have determined which connector style you have, we can get you upgraded to a V2! Below is the discounted upgrade pricing.
Style 1: $75 shipped - Our new V2 logos use the same style connector that you have, so you can get a direct upgrade! Please visit the link below to order your upgrade!
Style 2: $85 shipped - Your logo uses a similar style connector as our new V2 logos, but requires an additional adapter which we will provide for you. Please visit the link below to order your upgrade!
Upgrade to a V2 Lit Logo Here: https://lit-logos.com/products/v2-lit-logo-upgrade
Style 3 and 4: Unfortunately your style connector is incompatible with our new V2 logos. You will require an entirely new control box and logo, essentially a new kit. We can still get you upgraded to our V2, but the process looks a bit different. Please fill out the form below if you still want to upgrade and we'll get you taken care of!